Carpentry MCQ Multiple Choice Questions Answers - Page 5 | Quiz for Practice

Q: 61. The elevating crank is used to adjust

Correct Answer is: depth of cut.

Q: 66. The jointer is used to.............boards.

Correct Answer is: all of the above

Q: 68. The most common saw blades are.............blades.

Correct Answer is: all of the above

Q: 70. The reciprocating saw is used primarily for

Correct Answer is: rough cutting.

Q: 74. The thickness of a tenon should be..............the thickness of the piece in which the mortise will be cut.

Correct Answer is: between one-third and one-half

Q: 75. The three keys to good design include

Correct Answer is: appearance, sound construction, function.

Carpentry MCQ Questions for Practice

61. The elevating crank is used to adjust

cutting width.
angle of cut.
depth of cut.
none of the above.

62. The end of each piece in a miter joint is commonly cut at an angle of...................degrees.

90
30 or 60
45
none of the above

63. The ends of the socket piece in a dovetail joint are called

pins.
half-pins.
tails.
blind ends.

64. The first step in crosscutting operations is to put the............in place.

miter gauge
rip fence
sliding T-bevel
stop block

65. The first step in lumber processing is called

selective cutting.
barking.
air drying.
kiln drying.

66. The jointer is used to.............boards.

straighten
smooth
square up
all of the above

67. The most common lap joint is the.................joint.

surface-lap
end-to-end half-lap
cross-lap
half-lap

68. The most common saw blades are.............blades.

ripsaw
crosscut
combination
all of the above

69. The radial-arm saw is sometimes called a............saw.

cutoff
table
combination
back

70. The reciprocating saw is used primarily for

rough cutting.
curved cuts.
finish cutting.
all of the above.

71. The scroll saw is also called a

compass saw.
jigsaw.
coping saw.
band saw.

72. The size of a drill press is expressed as twice the distance from the center of the............to the column.

table
bit
chuck
spindle

73. The size of a power drill is determined by the size of its

bit.
chuck.
torque.
collar.

74. The thickness of a tenon should be..............the thickness of the piece in which the mortise will be cut.

twice
between one-third and one-half
less than one-fourth
three-fourths

75. The three keys to good design include

proportion, balance, symmetry.
appearance, sound construction, function.
function, harmony, emphasis.
sound construction, scale, evaluation.