Carpentry MCQ Multiple Choice Questions Answers - Page 4 | Quiz for Practice
Carpentry MCQ Questions for Practice
91. Veneering techniques have been used for at least..............years.
Correct Answer is: 3000
92. When adjusting the sliding compound miter saw, loosen the locking handle or lever and tilt the.............to the desired angle.
Correct Answer is: saw head
93. When applying a water-based stain, brush the end grain with.........to prevent it from absorbing too much stain.
Correct Answer is: water
94. When changing the belt on the stationary belt sander, first
Correct Answer is: remove the guards.
95. When cutting a rabbet by hand, make the shoulder cut with a
Correct Answer is: backsaw.
96. When cutting compound curves, first
Correct Answer is: make a pattern.
97. When cutting rectangular openings,
Correct Answer is: all of the above.
98. When edge jointing, hold the work face of the stock flat against the..............throughout the operation.
Correct Answer is: fence
99. When making a dowel joint in a frame, use a................to locate the dowels on the face surface.
Correct Answer is: try square
100. When making a miter cut, adjust the............to the angle desired.
Correct Answer is: overarm
101. When making a paneled door, use..............joints to connect stiles and rails.
Correct Answer is: mortise-and-tenon
102. When making biscuit joints, the slots should be slightly longer than the biscuits to allow for
Correct Answer is: adjustments and expansion.
103. When making edge joints, pieces of stock wider than..............inches should be ripped into narrower strips and the strips glued together.
Correct Answer is: 8 to 10
104. When making intricate internal cuts
Correct Answer is: all of the above.
105. When making straight cuts,
Correct Answer is: choose the widest blade possible.
106. When operating a portable power sander
Correct Answer is: all of the above.
107. When pieces of different thicknesses are joined, a.............joint is used.
Correct Answer is: full-lap
108. When planing a board, first
Correct Answer is: measure the thickness of the board at the thickest point.
109. When pre-drilling wood for screws, drill the...............in the first piece of stock, then hold this piece over the second piece to mark the location for the pilot hole.
Correct Answer is: shank clearance hole
110. When ripping with the table saw, use the..............to keep the saw kerf from closing.
Correct Answer is: splitter
111. When spraying finishes, wear
Correct Answer is: all of the above.
112. When storing a brush for a period of time, which of the following should not be done?
Correct Answer is: Soak up the wetness with newspaper.
113. When using a crosscut saw, which of the following is not recommended?
Correct Answer is: Cut with the grain.
114. When using a router with a jig and dovetail bit,
Correct Answer is: all of the above.
115. When using dowels to strengthen joints, their diameter should never be more than.............the thickness of the wood.
Correct Answer is: half
116. When white or yellow glue is used to apply veneer, the veneer is pressed with a
Correct Answer is: household iron.
117. When wood pieces are simply lapped without additional processing, the joint is called a(n)
Correct Answer is: surface lap joint
118. Which is not done when applying an oil-based stain?
Correct Answer is: Sponge the wood surface with water.
119. Which is not true for finish turning?
Correct Answer is: None of the above.
120. Which of the following can be used to cut veneer?
