Carpentry MCQ Multiple Choice Questions Answers - Page 6 | Quiz for Practice

Q: 77. The two basic types of hardware are cabinet hardware and

Correct Answer is: structural hardware.

Q: 78. The two main types of butt joints include edge butt joints and

Correct Answer is: end butt joints.

Q: 81. The width of the cut made for a rabbet joint is determined by the

Correct Answer is: thickness of the stock.

Q: 83. The.................presses firmly on the top of the wood to prevent the grain from tearing out.

Correct Answer is: chip breaker.

Q: 84. There are three basic steps to installing a drawer in a table:.............., making the drawer, and installing drawer guides.

Correct Answer is: cutting the rail

Q: 85. To cut a bevel, adjust the track for

Correct Answer is: straight crosscutting.

Q: 86. To cut a groove for a strip of inlay, use a.............bit.

Correct Answer is: left-hand spiral

Q: 88. To make a miter cut, adjust the miter gauge to the correct angle and proceed as for

Correct Answer is: crosscutting.

Carpentry MCQ Questions for Practice

76. The top grade of hardwood lumber is labeled

common yard lumber.
factory lumber.
yard lumber.
FAS.

77. The two basic types of hardware are cabinet hardware and

metal guides.
surface hardware.
structural hardware.
metal fasteners.

78. The two main types of butt joints include edge butt joints and

angled butt joints.
end butt joints.
face butt joints.
corner butt joints.

79. The vertical part of a shoulder is cut with a

hermaphrodite caliper.
gouge.
skew.
parting tool.

80. The width of a tenon should be............inches or less.

81. The width of the cut made for a rabbet joint is determined by the

thickness of the stock.
size of the saw blade.
desired strength of the joint.
size of the project.

82. The width of the mortise should be the same as the..............of the tenon.

radius
width
length
thickness

83. The.................presses firmly on the top of the wood to prevent the grain from tearing out.

outfeed roll.
infeed roll.
chip breaker.
pressure bar.

84. There are three basic steps to installing a drawer in a table:.............., making the drawer, and installing drawer guides.

drilling for brackets
cutting a rabbet
cutting the rail
measuring the lip

85. To cut a bevel, adjust the track for

cutting from the bottom.
ripping.
duplicate parts.
straight crosscutting.

86. To cut a groove for a strip of inlay, use a.............bit.

core box
beading
left-hand spiral
V-grooving

87. To lay out a dado, superimpose the end of the second board across the...............of the first.

none of the above
face
end
edge

88. To make a miter cut, adjust the miter gauge to the correct angle and proceed as for

cutting a taper.
ripping.
crosscutting.
chamfering.

89. To mix a white stain, combine..............with oil and turpentine.

white pumice
zinc oxide
raw sienna
burnt umber

90. Trim excess stock from a rabbet using a

sanding block.
file.
chisel.
jigsaw.