Carpentry MCQ Multiple Choice Questions Answers - Page 8 | Quiz for Practice
Carpentry MCQ Questions for Practice
106. When operating a portable power sander
Correct Answer is: all of the above.
107. When pieces of different thicknesses are joined, a.............joint is used.
Correct Answer is: full-lap
108. When planing a board, first
Correct Answer is: measure the thickness of the board at the thickest point.
109. When pre-drilling wood for screws, drill the...............in the first piece of stock, then hold this piece over the second piece to mark the location for the pilot hole.
Correct Answer is: shank clearance hole
110. When ripping with the table saw, use the..............to keep the saw kerf from closing.
Correct Answer is: splitter
111. When spraying finishes, wear
Correct Answer is: all of the above.
112. When storing a brush for a period of time, which of the following should not be done?
Correct Answer is: Soak up the wetness with newspaper.
113. When using a crosscut saw, which of the following is not recommended?
Correct Answer is: Cut with the grain.
114. When using a router with a jig and dovetail bit,
Correct Answer is: all of the above.
115. When using dowels to strengthen joints, their diameter should never be more than.............the thickness of the wood.
Correct Answer is: half
116. When white or yellow glue is used to apply veneer, the veneer is pressed with a
Correct Answer is: household iron.
117. When wood pieces are simply lapped without additional processing, the joint is called a(n)
Correct Answer is: surface lap joint
118. Which is not done when applying an oil-based stain?
Correct Answer is: Sponge the wood surface with water.
119. Which is not true for finish turning?
Correct Answer is: None of the above.
120. Which of the following can be used to cut veneer?
